Briggs-stratton 020239-0 User Manual download pdf (Page 12)

SpeedClean™ 2200 PSI Pressure Washer

4. Slide adjustable nozzle forward to low pressure mode.

Detergent cannot be applied with nozzle in high

pressure position.

5. Make sure garden hose is connected to water inlet.

Check that high pressure hose is connected to spray

gun and pump. Start engine.

6. Apply detergent to a dry surface, starting at lower

portion of area to be washed and work upward, using

long, even, overlapping strokes.

7. Allow detergent to "soak in" for 3-5 minutes before

washing and rinsing. Reapply as needed to prevent

surface from drying. DO NOT allow detergent to dry

on (prevents streaking).

IMPORTANT:You must flush the chemical injection

system after each use by placing the filter into a bucket of

clean water, then run the pressure washer in low pressure

for 1-2 minutes.

Pressure Washer Rinsing

For Rinsing:

1. Slide the nozzle backward to high pressure, press the

trigger and wait for the detergent to clear.

NOTE: You can also stop detergent from flowing by simply

removing chemical injection hose from bottle.

2. Keep the spray gun a safe distance from the area you

plan to spray.

3. Apply a high pressure spray to a small area, then check

the surface for damage. If no damage is found, it is okay

to continue cleaning.

4. Start at the top of the area to be rinsed, working

down with same overlapping strokes as you used for

washing and applying detergent.

Cleaning Chemical Injection Hose

If you used the chemical injection hose, you must flush it

with clean water before stopping the engine.

1. Place chemical injection hose in a bucket full of clean

water.

2. Slide adjustable nozzle forward to low pressure

position. Flush for 1-2 minutes.

3. Shut off engine.

IMPORTANT: Simply shutting OFF engine will not

release pressure in the system. When the engine has

shut down, squeeze the trigger on the spray gun to

relieve the pressure in the hose.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun,

circulating water in the pump can reach temperatures

above 125°F.The system engages to cool the pump by

discharging the warm water onto the ground.

• Keep spray nozzle between 8 to 24 inches away from cleaning

surface.

• Operate this unit on a stable surface.

• Be extremely careful if you must use the pressure washer from

a ladder, scaffolding or any other relatively unstable location.

• Firmly grasp spray gun with both hands when using high

pressure spray to avoid injury if gun kicks back.

High pressure spray could cause you to fall if

you are too close to the cleaning surface.

WARNING

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Briggs-stratton 020239-0 User Manual Page 12

Comments to this Manuals

Related products and manuals for Carwash Briggs-stratton 020239-0