Briggs & Stratton POWERBOSS 01648-1 Operator's Manual download pdf (Page 17)

TROUBLESHOOTING 4500W Portable Generator PowerBOSS™

TROUBLESHOOTING

Problem Cause Correction

No AC output is available, but

generator is running.

1. One of the circuit breakers is

open.

2. Fault in generator.

3. Poor connection or defective cord

set.

4. Connected device is bad.

1. Reset circuit breaker.

2. Contact Authorized service facility.

3. Check and repair.

4. Connect another device that is in

good condition.

Generator runs good at no-load

but "bogs" down" when loads are

connected.

1. Short circuit in a connected load.

2. Generator is overloaded.

3. Shorted generator circuit.

1. Disconnect shorted electrical load.

2. See "Don't Overload Generator".

3. Contact Authorized service facility.

Generator will not start; or starts

and runs rough.

Low oil level. Fill crankcase to proper level or place

generator on level surface.

Generator shuts down during

operation.

1. Out of fuel.

2. Low oil level.

1. Fill fuel tank.

2. Fill crankcase to proper level or

place generator on level surface.

Generator lacks power. Load is too high. See "Don't Overload Generator".

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

No comments

Briggs & Stratton POWERBOSS 01648-1 Operator's Manual Page 17