Briggs-stratton Elite Series 01804 User Manual download pdf (Page 6)

Pressure Washer

HOW TO USE PRESSURE

WASHER

If you have any problems operating your pressure washer,

please call the pressure washer helpline at 1-800-743-4115.

How to Start Pressure Washer

To start your pressure washer for the first time, follow

these instructions step-by-step.This starting information

also applies if you have let the pressure washer sit idle for

at least a day.

1. Place pressure washer near an outside water source

capable of supplying water at a flow rate greater than

3.5 gallons per minute and no less than 20 PSI at

pressure washer end of garden hose.

2. Check that high pressure hose is tightly connected to

spray gun and pump. See “Preparing Pressure Washer

for Use” for illustrations.

3. Make sure unit is in a level position.

4. Connect garden hose to water inlet on pressure

washer pump. Turn ON water.

CAUTION! DO NOT run the pump without the water

supply connected and turned on.You must follow this

caution or the pump will be damaged.

5. Attach adjustable nozzle extension to spray gun

(Figure 7).Tighten by hand.

6. Position nozzle in low pressure mode (see “How to

Use Adjustable Nozzle”) and squeeze trigger on spray

gun to relieve air pressure caused by turning ON

water.Water will flow out of spray gun in a thin

stream. Continue to hold trigger until there is a steady

stream of water and no air remains in system.This will

make it easier to pull start engine. Release trigger.

7. Engage safety latch to spray gun trigger (Figure 8).

8. Start engine according to instructions given in engine

owner’s manual.

NOTE: Always keep the throttle lever in the “Fast”

position when operating the pressure washer.

NOTE: If the recoil starter is hard to pull, squeeze the

spray gun trigger to relieve internal pump pressure.

How to Stop Pressure Washer

1. Let engine idle for two minutes.

2. Turn engine off according to instructions given in

engine owner’s manual.

3. Squeeze trigger on the spray gun to relieve

pressure in the hose.

NOTE: A small amount of water will squirt out when you

release the pressure.

Figure 7 — Connect Nozzle Extension to Spray Gun

Safety Latch

Figure 8 — Spray Gun with Safety Latch Engaged

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Briggs-stratton Elite Series 01804 User Manual Page 6

Comments to this Manuals

Related products and manuals for Carwash Briggs-stratton Elite Series 01804