Briggs & Stratton 1732 User Manual download pdf (Page 24)

Regular Maintenance

CHECK / LUBRICATE FREE-HAND

LINKAGE

Check the function of the Free-Hand controls: the con-

trols should function as described in the CONTROLS

section. It is critical for the safe operation of the unit

that the controls disengage when released.

Lubricate as shown in Figures 16-17.

Figure 17. Lubricate Free Hand Control

Figure 18. Lubricate Auger Shaft Assembly

A. Grease Fittings C. Cotter Pins

B. Shear Pins D. Auger Assembly

LUBRICATE AUGER SHAFT

ASSEMBLY

1. Remove cotter pin (C, Figure 18) and shear pin (B).

2. Use a grease gun and squirt several shots of grease

into grease fitting (A).

3. Rotate auger assembly (D) several times to distribute

the grease evenly. Repeat step 2.

4. Reinstall shear pin (B) and cotter pin (C).

5. Repeat procedure for other side.

Figure 16. Lubricate Free-Hand™ Control Linkage

A. DO NOT Lubricate Deflector Control

IMPORTANT NOTE

It is very important that grease fittings on the auger shaft

are lubricated regularly. If auger rusts to shaft, damage to

worm gear may occur if shear pins do not break.

IMPORTANT NOTE

If the controls do not function properly, lubricate them. If

lubrication does not rectify the problem, see your dealer.

Under no circumstances should the unit be used if the

controls are not functioning properly.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

Briggs & Stratton 1732 User Manual Page 24