Briggs & Stratton 210000 Specifications download pdf (Page 121)

118

NOTE: Do not apply force to the wire gauge! The

disc valve is retained by an internal bracket

which will be distorted if pressure is applied to

disc.

Figure 4

Install Breather

1. Place new gasket and breather assembly

on cylinder. Torque to screws to values

listed in Section 12 - Engine

Specifications.

2. Securely insert breather tube into breather

assembly.

Service Breather - Vertical Models

210000, 280000, 310000, 330000

Current Production

Remove Breather

1. Remove breather tube (B, Figure 5) from

breather cover (A).

Figure 5

2. Remove two screws (B, Figure 6),

breather cover. Discard gasket (before

date code 070719xx) or clean off sealant

(after date code 070718xx).

Figure 6

Check Breather

1. Remove and check breather reed

(A, Figure 7). If the reed is worn or bent, it

cannot function properly and must be

replaced.

Figure 7

2. Inspect the oil drain-back hole

(B, Figure 8). Insert a fine wire to ensure

the opening is not plugged.

Figure 8

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 178 179

No comments

Briggs & Stratton 210000 Specifications Page 121