Briggs & Stratton 210000 Specifications download pdf (Page 51)

Figure 40

Testing Battery

Set the digital multimeter to DC volts position.

Test the battery while installed in the equipment.

1. Disconnect wire from spark plug and

ground ignition using Ignition Tester

#19368.

2. Attach RED meter test clip to positive (+)

battery terminal. Attach BLACK meter test

lead to negative (-) battery terminal.

3. Turn switch to START. Meter should

display 9 volts or more while cranking

engine. If less than 9 volts, replace

battery.

NOTICE: To prevent damage to the starter

motor, do not crank starter for more than 15

seconds without allowing starter to cool at least 2

minutes.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 178 179

No comments

Briggs & Stratton 210000 Specifications Page 51