Briggs-stratton 01936 User Manual download pdf (Page 12)

Pressure Washer

GENERAL MAINTENANCE

RECOMMENDATIONS

The pressure washer warranty does not cover items that

have been subjected to operator abuse or negligence.To

receive full value from the warranty, the operator must

maintain the pressure washer as instructed in this manual.

• Some adjustments will need to be made periodically to

properly maintain your pressure washer.

• All maintenance in this manual and the engine owner’s

manual should be made at least once each season.

• If equipped with inflatable tires, keep the air pressure at

the value marked on the tire or within 15 and 40 psi.

PRESSURE WASHER

MAINTENANCE

Check In-Line Filter

Refer to Figure 22 and service the in-line filter if it

becomes clogged, as follows:

1. Detach spray gun and nozzle extension from high

pressure hose. Detach nozzle extension from spray

gun and remove o-ring and screen from nozzle

extension. Flush screen, spray gun, and nozzle

extension with clean water to clear debris.

2. If screen is damaged, the o-ring kit contains a

replacement in-line filter screen and an o-ring. If

undamaged, reuse screen.

3. Place in-line filter screen into threaded end of nozzle

extension. Direction does not matter. Push the screen

in with eraser end of pencil until it rests flat at bottom

of opening.Take care to not bend screen.

4. Place o-ring into threaded end of extension. Push

o-ring snugly against in-line filter screen.

5. Assemble nozzle extension to spray gun, as described

earlier in this manual.

Check and Clean Inlet Screen

Examine the screen on the water inlet. Clean it if the

screen is clogged or replace it if screen is damaged.

Check High Pressure Hose

The high pressure hose can develop leaks from wear,

kinking, or abuse. Inspect the hose each time before using

it. Check for cuts, leaks, abrasions or bulging of cover,

damage or movement of couplings. If any of these

conditions exist, replace the hose immediately.

WARNING! NEVER repair a high pressure hose.

Replace it with another hose that exceeds the

maximum pressure rating of your pressure washer.

Check Chemical Injection Hose

Examine the filter on the detergent tube and clean if

clogged.The tube should fit tightly on the barbed fitting.

Examine the tube for leaks or tears. Replace the filter or

tube if either is damaged.

Check Gun and Nozzle Extension

Examine the hose connection to the spray gun and make

sure it is secure.Test the trigger by pressing it and making

sure it “springs back” into place when you release it. Put

the safety latch in the ON position and test the trigger.You

should not be able to press the trigger.

Nozzle Extension

Filter Screen

O-ring

Figure 22 — Clean In-Line Filter

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Comments to this Manuals

No comments

Briggs-stratton 01936 User Manual Page 12

Comments to this Manuals

Related products and manuals for Carwash Briggs-stratton 01936