Briggs-stratton 592 User Manual

EdgerModel 592IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYTROY-BILT LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Warning: This unit is equ

10TrimmingPlacing the blade angle adjustment lever in the notch furthest to the left will put the spindle assembly at a proper angle for trimming with

11Figure 15Replacing the Edger Blade• Use two wrenches (one wrench to prevent the hex bolt head from spinning and the other to remove the hex lock nut

12Off-Season StorageObserve the following when preparing the edger for long-term storage:• Clean and lubricate unit thoroughly as instructed on page 1

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices ...3Assembling The Ed

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOTFOLLOWED, COULD ENDANGER THE

44. Never operate with damaged safety devices. Failure to do so, can result in personal injury.5. Never run an engine indoors or in a poorly ventilate

5SECTION 2: ASSEMBLING YOUR EDGERIMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After setting up the unit, service engine with gasoline and

6Figure 5IMPORTANT: Perform the clutch rod adjustment before operating the edger. Clutch Rod AdjustmentBefore operating the edger, check the adjustmen

7Figure 6SECTION 4: OPERATING THE EDGERThe operation of any edger can result in foreign objects being thrown into the eyes, which can result in sever

8• Move the throttle control lever on the engine into the STOP or OFF position.IMPORTANT: Make certain that the engine’s spark plug wire is properly g

9Edger Blade Angle AdjustmentWARNING: Rotating cutting blade may throwobjects causing personal injury. Keep areaclear of bystanders and do not operate