Briggs & Stratton 01931-0 Installation Manual download pdf (Page 4)

Bri_s & Stratton Power Products Home Generator

Installation Manual

I I

INSTALLATION

PROCEDURES

Unpacking Precautions

The unit is shipped bolted to its mounting pad, ready for

installation. Avoid damage from dropping, bumping, collision,

etc. Store and unpack carton with the proper side up, as

noted on the shipping carton.

CAUTION

• Observe that the 15 Amp fuse has been removed from the

control panel for shipping.

• DO NOT install this fuse until all plumbing and wiring has

been completed and inspected.

Delivery Inspection

After removing the carton, carefully inspect the Home

Standby Generator for any damage that may have occurred

during shipment.

IMPORTANT: If loss or damage is noted at time of

delivery, have the person(s) making delivery note all damage

on the freight bill and affix his signature under the

consignor's memo of loss or damage. If loss or damage is

noted after delivery, separate the damaged materials and

contact the carrier for claim procedures. Missing or

damaged parts are not warranted.

Shipment Contents

The Home Standby Generator is supplied with:

• Home Standby Generator

• Pre-attached mounting pad

• One 24" flexible hook-up hose

• Installation and start-up manual (P/N 194104GS)

• Owner's manual(P/N 194103GS)

• Illustrated parts list manual (P/N 193209GS)

• Product warranty sheet (P/N 190881GS)

• Installation checklist (P/N 190840GS)

• Three access door keys

• Four lifting hole plugs

• Oil fill spout

• Touch-up paint

• One spare 15A fuse

• Diagnostic LED kit (diode/plate/decal/pin connectors (2))

Required Specialty Tools/Equipment

• Two 48" lengths of I" OD pipe (NOT conduit)

• Hole punches for 16ga steel

• Torque screwdriver, 5 to 50 inch-pound range

Approved Transfer Switches

The Home Standby Generator should be used ONLY with

the following UL approved Transfer Switches. Connection

to any other transfer switch not listed below will void your

equipment warranty.

• 50A Nema I enclosure, BSPP Model 01917

• 50A Nema 3R enclosure, BSPP Model 01918

• 100A Nema 3R enclosure, BSPP Model 01813

• 100A Nema 3R enclosure w/main line disconnect, BSPP

Model 01928

• 200A Nema 3R enclosure, BSPP Model 01814

• 200A Nema 3R enclosure w/main line disconnect, BSPP

Model 01929

Home Standby Generator Location

TO THE INSTALLER: Consult with the owner(s)

and convey any technical considerations that might

affect their wishes, before applying these general

guidelines.

Generator Clearances

The generator enclosuremust be a minimum of 3 ft. (92cm)

from combustible material.Leaveat least 3 ft. (92cm) all

around the enclosurefor accessto the insideof the enclosure.

The unit's exhaust port must be at least 5 ft. (I 52 cm) from

any building opening (window, door, vent etc.), and the

exhaust must not be able to accumulate in any occupied

area (Figure I).

Exhaust

Exhaust port must be

5 ft (I 52 cm) minimum

distance from building

openings

1 2 3 4 5 6 7 8 9 ... 47 48

Comments to this Manuals

No comments

Briggs & Stratton 01931-0 Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Power generators Briggs & Stratton 01931-0