Briggs & Stratton 01931-0 Installation Manual download pdf (Page 15)

_] Briggs & Stratton Power Products Home Generator

Installation Manual

Utility Voltage Dropout Sensor

• This sensor monitors utility source voltage.

• If utility source voltage drops below about 70 percent of

the nominal supply voltage, the sensor energizes a

6-second timer.The timer is used to 'sense' brown-outs.

• Once the timer has expired, the engine will crank and

start.

Utility Voltage Pickup Sensor

This sensor monitors utility power supply voltage.When

that voltage is restored above 80 percent of the nominal

source voltage, a time delay starts timing and the engine

will go to engine cool-down.

Engine Cool-down Timer

• When the load is transferred back to the utility power

source, the engine cool-down timer starts timing.

• The timer will run for about one minute, then the

generator will stop.

• Minimum engine run time is 5 minutes.

SETTING EXERCISE TIMER

The Home Standby Generator is equipped with an exercise

timer that will start and exercise the system once every

seven days. During this exercise period, the unit runs for

approximately 20 minutes and then shuts down. Electrical

load transfer DOES NOT occur during the exercise cycle

(unless an utility power outage occurs).

A switch on the control panel is labeled "Set Exercise" (see

Figure I I).The specific day and the specific time of day this

switch is pressed is programmed into the control board

memory.This date and time is then used to automatically

initiate the system exercise cycle.

To perform the Set Exercise procedure:

I. Choose the day and time you want your Home

Standby Generator to exercise.

2. On that day and time, set the AUTO/OFF/MANUAL

switch to OFF.

3. Pressand hold down the "Set Exercise" switchfor two

seconds.

4. Set the AUTO/OFF/MANUAL switch to AUTO. "Set

Exercise" is complete.

For example, if you press the "Set Exercise" switch on

Sunday morning at I0:00 AM, the unit will run an exercise

cycle the following Sunday at 10:00 AM (+/- I/2 hour).

NOTE: "Set Exercise" will only work if the unit is in the

Automatic mode and this exact procedure is followed.The

exerciser does not need to be re-set if the 15Amp fuse is

removed or changed.The exerciser will need to be re-set if

the 12Volt DC battery is disconnected.

If you want to change the day and time the unit exercises,

simply perform the "Set Exercise" procedure at the exact

weekday and time you want it to take place.

INSTALLATION

INSPECTION

Before placing the Home Standby Generator into service,

inspect the entire installation carefully. Ensure that any

scratches or broken paint on the inside or outside of the

enclosure are touched up with the supplied paint.

Complete the "installation Checklist" as you make the

inspection. Ensure all items have been filled-in and all

signatures have been obtained. Instruct the owner to mail

the white copy to:

Briggs & Stratton Power Products

Warranty Registration

P. O. Box I 144

Milwaukee,WI 53201-1144

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comments to this Manuals

No comments

Briggs & Stratton 01931-0 Installation Manual Page 15

Comments to this Manuals

Related products and manuals for Power generators Briggs & Stratton 01931-0