Briggs & Stratton 1679-0 Installation Manual download pdf (Page 10)

C_m_ @y60_'s C_, h_mM_

Bri_,_s& Stratton Power Products Home Generator System

Installation Manual

ESSENTIAL CIRCUIT

ISOLATION

Essentialelectrical loadsare loadsthat will be powered by

the Home Generator System.Essentialloads are grouped

together and wired into the transfer switch.

A AUTION!This Home Generator System MUSTbe installed as described herein.

TO THE INSTALLER: Consult with Home

Generator System owner(s) to discusstheir

"Selection of EssentialCircuits", described in the

owner's manual.

Ensure that the total of the selected loadcircuits fed by this

transfer switch are within the generator's rated capacity.

The following requirements apply to this type of isolation

system:

• The Automatic Transfer Switch is installed after the main

distribution panel.

• The AutomadcTransfer Switch hasa load rating of

50 Amps.This is the maximum load rating of the essential

loads.

All wiring must conform to the National Electrical Code,

and all state and local codes.

The illustration in Figure I I depicts the Home Generator

System and assumesthe utility is supplying 120/240Volt,

slngle-phaseelectrical service.

240V

To Utility Power

Watt Meter

....... _____

...... i Main Distrubution Panel

[ ToWater Heater _ To Air Conditioner (240V)

' To Other Circuits (120V)

III i

To Briggs & Stratton J

Home Generator Unit

120VTo Microwave

120V To Bathroom

240V To Well Pump

120VTo Sump Pump

.J-------J

-,,

,, Automatic Transfer Switch

i (in normal position)

t20V To Freezer

iTo Refrigerator

1 . 120V

-- i To Lights

-- _ ',lIT°Furnace glowerJ

Neutral

I i

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Comments to this Manuals

No comments

Briggs & Stratton 1679-0 Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Power generators Briggs & Stratton 1679-0