Briggs & Stratton 1679-0 Installation Manual Page 17
- Page / 60
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Bri_,_s& Stratton Power Products Home Generator System
Installation Manual
C_ byEe_'sCu_Hammet
Checking Automatic Operation
To check the system for proper automatic operation,
proceed as follows:
I. Check thatAUTO/OFF/MANUAL is set to OFF.
2. Apply utility power to the Automatic Transfer Switch
by turning ON the main distribution panel circuit
breaker.
3. Set the AUTO/OFF/MANUAL switch to AUTO.The
Automatic Power System is now ready for automatic
operation.
4. Turn OFF the main distribution panel circuit breaker
sending power to the automatic transfer switch.
The engine will crank and start after sensors havetimed
out, After starting, the Automatic Power Transfer System
will transfer essential circuit loads to the generator. Let the
system go through its entire automatic operation sequence.
5. With the generator output supplying its loads,turn
ON the main distribution panel circuit breaker that
supplies utility power to the Automatic PowerTransfer
Switch.
6. After about 6 seconds,the automatic transfer switch
will transfer loads back to the utility power.
7. About one minute after re-transfer, the generator will
stop.
This completes the test procedures for the automatic
operation of the Home Generator System.
SETTING EXERCISE TIMER
The Home Generator System is equipped with an exercise
timer that will start and exercise the system once every
sevendays.During this exercise period, the unit runs for
approximately 12 minutes and then shuts down. Electrical
load transfer DOES NOT occur during the exercise cycle
(unless an utility power outage occurs).
A switch on the control panel is labeled"Set Exercise" (see
Figure 16).The specific day and the specific time of day this
switch is pressed is programmed into the control board
memory.This date and time isthen used to automatically
initiatethe system exercise cycle.
To perform the Set Exercise procedure:
I. Choose the day and time you want your Home
Generator Systemto exercise.
On that day and time, set the AUTO/OFF/MANUAL
switch to OFF.
2.
3. Pressand hold clown the "Set Exercise" switch until
the Diagnostic LED turns on (about five seconds).
4. Hold the switch down until the Diagnostic LED turns
off. Releasethe Set Exercise switch.
5. Set the AUTO/OFF/MANUAL switch to AUTO. "Set
Exercise" iscomplete.
For example, if you press the "Set Exercise" switch on
Sundaymorning at I0:00 AM, the unit will run an exercise
cycle the following Sundayat I0:00 AM.
NOTE: "Set Exercise" will only work if the unit is in the
Automatic mode and this exact procedure is followed.The
exerciser does not need to be re-set if the 15Amp fuse is
removed or changed.The exerciser will need to be re-set if
the 12Volt DC battery is disconnected.
If you want to change the day and time the unit exercises,
simply perform the "Set Exercise" procedure at the exact
weekday and time you want it to take place.
/
17
- SAFETY RULES 3
- INSTALLATION 4
- PROCEDURES 4
- Lifting the Generator 5
- Access Doors 6
- THE GASEOUS FUEL 7
- Fuel Consumption 9
- Fuel Pipe Sizing 9
- ESSENTIAL CIRCUIT 10
- ISOLATION 10
- TRANSFER SWITCH 11
- Power Wiring Interconnections 12
- Grounding the System 13
- Fault Detection System 13
- System Control Panel 13
- BEFORE INITIAL ENGINE 14
- INITIAL START-UP (NOLOAD) 15
- AUTOMATIC OPERATION 16
- SEQUENCE 16
- SETTING EXERCISE TIMER 17
- RECONFIGURING THE 18
- FUEL SYSTEM 18
- POST INSTALLATION 19
- INSPECTION 19
- REFERENCES 19
- Fuel Comparison Chart 20
- Half Full 20
- INSTALLATION NOTES 21
- Manual de Instalaci6n 22
- PROCEDIMIENTOS DE 24
- INSTALACION 24
- Electricidad y Combustible 25
- Elevaci6n del Generador 25
- Puertas de Acceso 26
- SISTEMA DE COMBUSTIBLE 27
- ImrFal,z.lm;_i 29
- AISLAMIENTO DE LOS 30
- CIRCUITOS FUNDAMENTALES 30
- CONMUTADOR DE 31
- TRANSFERENCIA 31
- _ IC°nex'6ndeI 32
- C_ byEe_'sCu_Hemmet 33
- ANTES DEL ARRANQUE INICIAL 34
- DEL MOTOR 34
- ARRANQUE INICIAL (SIN CARGA) 35
- SECUENCIA DE OPERACI( N 36
- AUTOMATICA 36
- CONFIGURACION DEL 37
- TEMPORIZADOR DE PRACTICA 37
- RECONFIGURACION DEL 38
- INSPECCI¢ N POSTERIORA LA 39
- C_ byEe_'sCu__et 40
- Guide d'lnstallation 42
- C_eo_byEa_'sCu__e 44
- C°nnztZ db 7 °r'eo 45
- Fortes d'Acc_s 46
- LE SYSTI=ME DE COMBUSTIBLE 47
- Consommation de Combustible 49
- ISOLATION DES CIRCUITS 50
- ESSENTIELS 50
- COMMUTATEUR DE TRANSFERT 51
- Interconnexions du Cgblage 52
- Mise _ la Masse du Syst_me 53
- AVANT LE DI MARRAGE INITIAL 54
- DU MOTEUR 54
- DEMARRAGE INITIAL (SANS 55
- SEQUENCE DE 56
- FONCTIONNEMENT 56
- AUTOMATIQUE 56
- RI GLAGE DE LA MINUTERIE DE 57
- CYCLE D'EXERCICE 57
- RECONFIGURATION DU 57
- SYSTI=ME DE COMBUSTIBLE 57
- VIERIFICATION POST 58
- C_eoEbyEa_'sCu_Hemmet 59
Related products and manuals for Power generators Briggs & Stratton 1679-0
(1 pages)
(40 pages)
(84 pages)
(28 pages)© 2020, manymanuals.com. All rights reserved. | 1.522 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals