Briggs & Stratton 1679-0 Installation Manual download pdf (Page 12)

Bri_,_s&StrattonPowerProductsHomeGeneratorSystem

Installation Manual

Power Wiring Interconnections

All wiring must be the proper size, properly supported, of

approved insutative qualities, and protected by NEC

approved conduit Use flexible conduit between the

enclosure and any rigid conduit

_ AUTION! Per NEC code, power voltage leads

must be run in separate conduit from low voltage

transfer switch "signal" leads.

Complete the following connections between the

generator, transfer switch and main distribution panel

(Figure 14).

I. Connect utility power supply leads from a two pole

breaker installed in the main distribution panel to

transfer switch terminals marked "UTILITY

CONNECTION". Use a 50Amp circuit breaker.

Ensure breaker is turned OFF.

2. Connect utility neutral to the transfer switch

"NEUTRAL" bus.

3. Connect utility ground to the transfer switch"GND"

bus.

4. Connect generator power supply leads from the

generator's control panel to transfer switch terminals

marked "GENERATOR CONNECTION".

Connect generator Neutral from the control panel to

the transfer switch NEUTRAL bus.

Connect generator GND from the control panel to

the transfer switch GND bus.

Torque all wire connections/fasteners to values

recommended in Figure 15.

Main DiagnosticLED

DistributionPanel

Neutral Ground

Bus Bus

EE3

[_ Utility

_ Connection

Dual Pole

Breaker

Automatic Power Transfer Switch

Home Generator Rear of

Neutral System Control

Bus Generator Panel

Generator

Neutral is

White wire

Generator

Connection

Wire

GND

[]

Control Signal

Connections

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Comments to this Manuals

No comments

Briggs & Stratton 1679-0 Installation Manual Page 12

Comments to this Manuals

Related products and manuals for Power generators Briggs & Stratton 1679-0