Briggs & Stratton 1679-0 Installation Manual download pdf (Page 6)

C_ byEe_'sCu__et

Bri_,_s& Stratton Power Products Home Generator System

Installation Manual

To lift:

Insert

pipe

here

Installer-supplied pipe

You mayalso lift the unit using a"hook and hoist" method

attached to the lifting pipes,provided that you use a

spreader bar to ensure that the chains or cablesdo not

touch the generator's roof.

Retouch any chipped paint with supplied touch-up paint

After paint is dry, and the unit is in place,fill the lifting

holes with the supplied lifting hole plugs.

Access Doors

The Home Generator System is equipped with an

enclosure having four accessdoors.As shown in Figure 4,

below, the doors are named for a significant component

located behind them.Also shown is the unit's dimensions.

Starting with the side that has the fuel piping connector

and proceeding clockwise, the doors are named:

• Oil Service door

• Air Intake door

• Control Panel door

• Battery door

Each unit is equipped with three identical circular keys.

These keysfit the locks that secure the oil service and

control panel doors.

To remove an access door:

I. Insert a key into the lock of the accessdoor you wish

to remove and turn one quarter turn clockwise.

NOTE:The key is retained in the lock when the locks are

open.

2. Grasp the door's lift handle and pull the door upwards

until the security pins are free of the engagementholes

in the lower base.

Door Lock J

Screw

Fuel

Inlet

oo o<

Exhaust

Port

29,,

Door L

Lock _/_

Screw

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Comments to this Manuals

No comments

Briggs & Stratton 1679-0 Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Power generators Briggs & Stratton 1679-0